Part of this, the following megatec options, in ups. It is necessary to put the device file as after configuring nut. Defaults to 30 seconds. Note however, that this heavily relies on the values you enter and that the UPS must be able to report the load as well. If you want the driver to report a guesstimated battery. The argument is a regular expression that must match the bus name where the UPS is connected e.
|Date Added:||8 April 2006|
|File Size:||12.12 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Only users with topic management privileges can see it. I tried usbhid-ups driver with no result as is described in my initial text. Try to use the config from this blogger: Probably best to diagnose things directly via the NUT command line tools rather than the package gui.
Bus Device If you specify both battery. Saved my life ;! I was able to get it to run at one point but with an error that it could not get a status from the UPS but I can’t reproduce it. All results what did I get was that driver is not running and UPS is not recognized. This complements Grin’s solution. Unit is Eaton 5E. Hi all, First post, long time lurker, props to everyone for the work on 2. If not specified, the driver defaults to seconds 12 hours. Not available on some hardware.
[Nut-upsuser] connection pb with blazer_usb with infusec UPS
Uses the timers defined by ondelay and offdelay. Note that a value below 3 minutes, may cause earlier firmware versions to not switch on automatically, so it defaults to 3 minutes. As a result, your viewing experience will be diminished, and you may not be able to execute some actions. Product information, software announcements, and special offers. The argument is a regular expression that must match the bus name where the UPS is connected e.
For instance, if battery. What kind of driver is suitable for me and what kind of settings?
Only used if runtimecal is also specified. I did try your chmod method with no error, but upsdrvctl start beaves the same.
The NUT compatibility table lists all the known supported models. Setting this flag will make the driver skip this step. Hope someone can help as rainy season just started and that’s when problem can arise with storms.
If you specified the runtimecalthe driver will attempt to do this. It might be worthwhile checking the cables also.
USB UPS management/control – Raspberry Pi Forums
Part of protcool, the following megatec options, in ups. Defaults to 30 seconds. Try -DD for finding out the strings to match. The driver will attempt to detect this automatically, but if this fails somehow, you may want to override this value.